Trends in education, 2013 (vol. 6), issue 1

TVV 2013, 6(1):128-131

INFLUENCE OF PROCESS PARAMETERS ON PULSED ND:YAG LASER CUTTING OF SOME METALS

ŘIHÁKOVÁ Lenka1, CHMELÍČKOVÁ Hana2, TOMÁŠTÍK Jan3
1 Společná laboratoř optiky UP a FZÚ AV ČR, Přírodovědecká fakulta UP, 17. listopadu 50A, 772 07
2 Fyzikální ústav AV ČR, Společná laboratoř optiky UP a FZÚ AV ČR, 17. listopadu 50A, 772 07

This article describes pulsed laser cutting and focuses on the effect of process parameters on the kerf width and its quality. These parameters include output power, cutting speed and assist gas pressure. Confocal microscopy was used for samples analyze.

Keywords: laser, pulsed cutting, kerf width

Published: July 1, 2013  Show citation

ACS AIP APA ASA Harvard Chicago Chicago Notes IEEE ISO690 MLA NLM Turabian Vancouver
ŘIHÁKOVÁ, L., CHMELÍČKOVÁ, H., & TOMÁŠTÍK, J. (2013). INFLUENCE OF PROCESS PARAMETERS ON PULSED ND:YAG LASER CUTTING OF SOME METALS. Trends in education, 6(1), 128-131
Share...
Download citation
  • BibTeX (.bib)
  • Bookends (.ris)
  • EasyBib (.ris)
  • EndNote (.enw)
  • EndNote 8 (.xml)
  • ISI WoS (.isi)
  • Medlars (.medlars)
  • Mendeley (.ris)
  • MODS (.xml)
  • Papers (.ris)
  • RefWorks (.txt)
  • RefManager (.ris)
  • RIS (.ris)
  • MS Word (.xml)
  • Zotero (.ris)
    • Open full article

    References

    1. ION, J. C. Laser Processing of Engineering materials. Burlington: Elsevier, 2005. ISBN 0-7506-6079-1
    2. DAHOTRE, N. B., HARIMKAR, S. P. Laser Fabrication and Machining of Materials. New York: Springer, 2008. ISBN 978-0-387-72343-3

    This is an open access article distributed under the terms of the Creative Commons Attribution-ShareAlike 4.0 International License (CC BY-SA 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.


    Return to the content