Trends in education, 2012 (vol. 5), issue 1
TVV 2012, 5(1):204-207
NEW TRENDS IN TEACHING THE THEORY OF MANUFACTURING AT UNIVERSITIES
- Katedra výrobných technológií, Fakulta výrobných technológií so sídlom v Prešove, Technická univerzita v Košiciach, Štúrova 31, 080 01 Prešov, SR,
The paper dealt with new approaches in field of teaching technological subjects at universities. The present available systems in diagnostics and informatics are used in monitoring and evaluation of manufacturing process. The paper describes suggestion of workplace for monitoring and evaluation that is connected to internet. The realized experiments are watched, monitored, analysed and evaluated that allows for students information access without restrictions even in repeated regime.
Keywords: interaction, manufacturing process, WiFi device, knowledge.
Published: July 1, 2012 Show citation
References
- JURKO, J.: Machinability during turning of steels, In: Studia i materialy. Vol. 26-29, No. 1-2 (2010), p. 14-19. ISSN 0860-7761.
- MICHALIK, P., - ZAJAC, J.: Intelligently programming of holes machining, 2010. In: Výrobné inžinierstvo. Roč. 9, č. 4 (2010), s. 63-65. - ISSN 1335-7972.
- MURČINKOVÁ, Z.: Simulation of notch influence by using Pro/Mechanica software, Trends in education 2009: Conference on trends in Education, Olomouc, CZ, 2009 ISBN 978-80-7220-316-1, 148 -152s.
- VASILKO, K.: Analytická teória trieskového obrábania,(COFIN, Prešov 2009).
This is an open access article distributed under the terms of the Creative Commons Attribution-ShareAlike 4.0 International License (CC BY-SA 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.